Mesko MS 5028 Mode D'emploi page 84

Оставете ютията да се охлади напълно, преди да я приберете.
21. Ако не използвате ютия, дори и за кратко време, изключете опциите за пара
22. В никакъв случай не трябва да се гладят дрехи и тъкани, които са върху хора или
животни.
23. Никога не насочвайте парата към хора или домашни любимци.
24. Използвайте функцията за самопочистване поне веднъж месечно.
25. Ютията трябва да се използва на стабилна равна повърхност и може да се
изхвърли само.
26. Не пълнете резервоара за вода с химикали, парфюми или вещества за
отстраняване на котлен камък.
DESCRIPTION OF DEVICE
A. Spray nozzle
C. Steam Control Lever
E. "Steam blast" button
H. Thermostat indicator light
G. Thermostat knob - temperature control
K. Water tank
ANTI-CALC function
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the plate. The resin filter is permanent and
does not need replacing.
PLEASE NOTE: Use tap water only. Distilled and/demineralised water makes the "Zero-Calc" anti-calc system ineffective by altering its
physicochemical characteristics.
Self-Clean Function
It is recommended that you periodically use the soleplate Self-Clean function which prevents scale build-up in your iron. In order to do this,
fill your iron entirely with water, sit it on its heel, connect to the mains and set the thermostat to "MAX". When the control light goes out,
disconnect the device from the mains and hold it in a horizontal position, e.g. over a sink. Move the Self-Clean button (J)to right side and
hold the iron for about a minute, shaking it. When it cools down, clean the soleplate with a moist cloth to remove any dirt.
IRONING
First use
When using the iron for the first time, you may notice a slight emission of smoke and hear some sounds made by the expanding plastics.
This is quite normal and it stops after a short time. We also recommend passing the iron over an ordinary cloth when using it for the first
time.
Preparation
Sort the laundry to be ironed according to the international symbols on the garment label, or if this is missing, according to the type of
fabric.
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down) and eliminates the risk of scorching the fabric.
B. The water inlet hole
D. Spray button
F. Power Cord
J. Self-clean button
I. Soleplate
84