Siemens RE8ST Montage page 2

en Operation
Intended use
The RE8ST Testifire 1001-045 ST test kit is a tool for
checking the function of smoke and heat detectors. To run
this check, a heating element is heated in a tester until the
heat detector being checked issues an alarm.
Smoke detectors are tested by setting off a smoke capsule in
the tester.
The following modules form part of the RE8ST test kit:
· 1x Testifire 1001-045 tester
· 2x RE7T-B1 Solo770 rechargeable batteries for the
tester
· 1x RE-8S smoke capsule
· 1x RE7T-C1 Solo727 charger for rechargeable
battery
· 2x mains cable for charger RE7T-C1 Solo727
· 1x Quick Start User Guide
· 1x Installation Instructions RE8ST and RE8STCO
(this document)
The RE8STCO Testifire 2001-045 STCO test kit is a tool for
checking the function of smoke, heat, and CO detectors. To
run this check, a heating element is heated in a tester until
the heat detector being checked issues an alarm.
Smoke detectors are tested by setting off a smoke capsule in
the tester.
CO detectors are tested by setting off a CO capsule in the
tester.
The following modules form part of the RE8STCO test kit:
· 1x Testifire 2001-045 tester
· 2x RE7T-B1 Solo770 rechargeable batteries for the
tester
· 1x RE8-S smoke capsule
· 1x RE8-CO CO capsule
· 1x RE7T-C1 Solo727 charger for rechargeable
battery
· 2x mains cable for charger RE7T-C1 Solo727
· 1x Quick Start User Guide
· 1x Installation Instructions RE8ST and RE8STCO
(this document)
2
Building Technologies
Fire Safety
All manuals and user guides at all-guides.com
Installing FDUM29x telescope rods (Fig. 1)
1.
2.
3.
Additional information
In the Quick Start Guide from No Climb Products Ltd.
supplied with the test kit, you will find information on the
following topics:
WARNING
Use of the RE8ST and RE8STCO test kits in
electrical switching stations or areas where there is
a danger of explosion.
Danger to life
· Do not use the RE8ST and RE8STCO test kits in
electrical switching stations or areas where there
is a danger of explosion.
CAUTION
Falling objects
Risk of injury
· Wear a hardhat when working with telescope
rods.
Insert the rechargeable battery (2) into the tester (1).
Fit the Solo719 adaptor RE7T-A (3) on the rechargeable
battery (2).
Fit a FDUM29x telescope rod (4) on the Solo719 adapter
RE7T-A (3).
· Safety information for operating the test kit
· Operation of the test kit
· Procedure for testing detectors
· Replacing capsules
· Replacing and charging the rechargeable battery
You can download the detailed User Manual for the
test kits from: www.testifire.com.
A6V10387053_e_--_--
2018-05-31