Télécharger Imprimer la page

Eldom Aromi C295C Mode D'emploi page 10

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
OPERATING INSTRUCTION
EN
OPERATING INSTRUCTION
CORDLESS KETTLE C295C
CORDLESS KETTLE C275B/C275C
GENERAL DESCRIPTION
1.
Spout + net filter
2.
Opening lid
3.
Handle
4.
Water level indicator
5.
On/off switch + control lamp
6.
Rotating base
INTENDED USE
Cordless kettle C295C is for boiling water. It is possible to boil 0.5 – 1.7 litre of water in the kettle.
OPERATION
The kettle base (6) must be put on a flat and dry surface.
In the base there is some space for an excess cord. It is important for the cord to be led
from the base (6) through a special groove so that the appliance could be stable.
Before using the kettle for the first time fill it up (2-3 times) with water, boil the water
and then empty the kettle.
The kettle can be filled with water directly through the spout (1) or after opening the lid (2).
The kettle must not be filled up when on the base. Before switching on the kettle, make
sure that the lid (2) is properly fastened.
The minimum level of boiling water is 0.5 l. The maximum water level (1.7 l) is marked on
the indicator (4).
The kettle starts working after putting the switch (5).
The kettle working is signalled by the control lamp (5).
The kettle switches off automatically after the water has boiled.
You can stop heating water at any time by putting the switch (5) in the position '0'.
FILTER
The filter does not remove the scale, but it prevents any deposits from getting inside the kettle while
the water is being poured in. The filter should be cleaned regularly. Hard water may block the filter
after boiling water a couple of times.
CLEANING AND MAINTENANCE
Allow the unit to cool down completely before cleaning.
Do not immerse the kettle in water while washing up.
The outside of the kettle may be wiped over with a damp cloth and washing-up liquid.
Water stains inside the kettle can be removed by rubbing with a cloth moisten with white
vinegar; rinse the inside with water afterwards.
Limescale should be removed in the following way:
10
fill the kettle with 0.75 litre of water and bring it to boil,
switch the kettle off and disconnect the kettle from the power supply,
pour 0.1l of vinegar into a jug and leave the solution for a few hours,
discard the solution and rinse the inside with water,
fill the kettle with 1 litre of water and bring to boil,
discard the water and rinse the inside with water.
TECHNICAL DATA
power: 1800-2150 W
mains voltage:
220-240V ~ 50/06Hz
1.7 litre capacity

Publicité

loading