Technical Specifications - ESSSE CAFFE S.12 Mode D'emploi

EN
TROUBLESHOOTING
PROBLEM
The machine does not turn on.
Cannot close the capsule
insertion sliding board.
Pump very noisy.
The machine does not dispense
coffee.
The coffee is not hot enough.
Button 1 blinks amber.
Buttons 2/3 blink blue.
For other problems or if the above solutions do not resolve the problem, contact customer service.

TECHNICAL SPECIFICATIONS

See technical data plate on the bottom of the machine.
Type of product to be used:
Ejection:
Dimensions (L x H x D):
Weight (approximate):
Water tank capacity:
Used capsule drawer capacity:
Discharge basin capacity:
Insulation class:
Power:
Voltage:
Frequency:
ESPRESSO AND HOT DRINK MACHINE WHICH USES SINGLE-DOSE CAPSULES
POSSIBLE CAUSE
> Machine not plugged in, or no
electricity.
> ON/OFF switch in OFF position.
> Used capsule drawer full.
> Capsule inserted wrong.
> No water in water tank.
> Capsule not inserted.
> Capsule inserted is not an Essse
Sistema Espresso capsule.
> Operating temperature not yet
reached.
> Capsule insertion sliding board
open.
> No water in water tank.
> The cups are too cold.
> It's necessary to descale the
machine.
> The machine is broken and needs
repair.
Essse Sistema Espresso Capsules
Automatic ejection of the capsule
135 mm x 265 mm x 295 mm
3.5 kg
1.0 lt
12 capsules
0.35 lt
Class I
See technical data plate on the bottom of the machine
See technical data plate on the bottom of the machine
See technical data plate on the bottom of the machine
24
POSSIBLE SOLUTION
> Verify correct insertion of plug
into outlet.
> Turn machine on by placing
ON/OFF switch in ON position.
> Empty used capsule drawer.
> Open capsule insertion sliding
board and insert capsule
correctly.
> Fill with clean drinking water
and repeat the hydraulic circuit
charging process.
> Insert capsule.
> Insert Essse Sistema Espresso
capsule.
> Wait until correct operating
temperature is reached.
> Close the sliding board.
> Fill with clean drinking water
and repeat the hydraulic circuit
charging process.
> Preheat the cups by dispensing
hot water or use plastic cups.
> Perform the descaling operation
on the coffee machine.
> Contact service center.