Braun BC13 Mode D'emploi page 3

Placing the sensor outside
1. Place the sensor outside within a 30 metre (98ft) range of the
main unit.
2. The sensor can be placed vertically on flat surface under a
covered area which can shield it from direct sunlight or wet
conditions for an accurate reading. Or it can be mounted on a wall
with a screw.
3. Extreme temperatures, placing on wet surface and shock
should be avoided to prevent damage.
Note:
1. If no signal is received or the transmission is interrupted, the
"- -" symbol will appear on the LCD display.
2. Ensure that the main unit and the sensor are placed within a
30 metre (98ft) range from each other. Press the PAIR button to
receive the sensor signal.
3. If the "- -" symbol is still showing on the LCD display, please
reset the main unit and then the sensor.
4. The temperature and humidity ranges are as follows. It will
display HH when the environment is higher than this range. It will
display LL when the environment is lower than this range.
Temperature Humidity
Main unit -10 ~ 50 ºC 20 ~ 95%
Sensor -20 ~ 60 ºC 20 ~ 95%
Weather forecast indicator
The built-in barometer can detect atmospheric pressure changes.
Based on the data collected, it can predict the weather condition
(Image 5) in the forthcoming 12 to 24 hours.
Note:
The weather forecast predicts the weather condition in the
forthcoming 12 to 24 hours. It may not necessarily reflect the
current situation. We do not accept any liability which may occur
as a result of an incorrect weather forecast.
Setting the night light
1. Slide the BACKLIGHT switch to ON position to enable the night
light mode.
2. Slide the BACKLIGHT switch to OFF position to disable the
night light mode.
Note: The backlight will only turn on in low-light conditions, such
as in a dark room. If this feature is used continuously, the battery
life will be greatly reduced.
Battery replacement
When the 'Low battery indicator' is visible on main unit, replace
with two new AA batteries at once.
When the 'Low battery indicator' is visible on sensor, replace with
two new AAA batteries at once. Press the PAIR button on main
unit to receive the sensor signal.
Note: Exposure to an electrostatic environment may cause the
clock to reset. In this event please follow the instructions as
described in this manual to set the clock again.
Guarantee
2 year guarantee against material and workmanship defects
(except battery). The guarantee is valid in those countries where
the alarm clock is officially being sold.
Broken or cracked lens screens are not covered under the
Guarantee.
Braun helpline
Should you have a problem with your product, please check your
local service centre at:
www.braun-clocks.com
www.braun-watches.com
or contact +44 808 175 3235 (calls free within the UK)
or +44 208 208 1833.
WARNING! This product is covered by the Waste Electrical and
Electronic Equipment (WEEE) directive. It should not be discard-
ed with normal household waste but taken to your local collec-
tion centre for recycling.
This product conforms to the EMC requirements as per council
directive 2014/30/EU.
Certain trademarks used under license from the Procter & Gam-
ble Company or its affiliates.