Fault analysis and elimination
Fault phenomenon
Cause analysis
The power plug is not connected properly
The power cord is broken
The machine is not
Dry burning is protected
heated
Thermostat is broken.
Internal wires is loose or poor contact is poor
The kettle body is not put in or not put in the
base correctly.
Key does not work
Switch is broken.
The water is
Electronic board is broken.
boiling with power
continuous on.
Temperature probe is broken.
Display E1
NTC is open-circuited.
Display E2
NTC is short-circuited.
Display E3
Dry burning.
Water has
This phenomenon usually occurs when
abonormal smell.
useing it for the first time.
There is scale in the
The cause it that the local water quality is
kettle, or the water in the
hard, caused by calcium carbonate and
kettle becomes muddy.
magnesium carbonate in the water.
Fault elimination
Please check the connection of power plug.
Please change it at the after-sales service site
before using it.
After the power is turned off, please add
appropriate amount of cold water into the kettle.
It shall be be sent to the maintenance station to
replace the thermostat.
Plug the wire tightly.
Put the kettle back to the base correctly.
Replace switch
Send to the maintenance station to replace the
electronic board.
Send to maintenance station to replace sensor.
Turn off the power supply and add appropriate
amount of cold water to the left.
Turn off the power supply, unplug, and contact the
after-sales service center.
Turn off the power supply, unplug it, and contact
the after-sales service center (Attention: it does not
need to be repaired with E3 dispay if the kettle is
not put, just put the kettle on)
1. Solve it according to the method in article 5 of
the "Use Method"
2. If this problem still exists, add water to the kettle
to the maximum scale, add 2 spoonfuls of baking
soda, boil the water, and then pour it out.
Remove the scale in time.
- 8 -
Deutsch
Gebrauchsanweisungen
(Hinweis: Das Produkt unterliegt dem tatsächlichen Produkt)
- 9 -
TN1815