Publicité
Les langues disponibles
Les langues disponibles
● Flame Effect: Toggle the power switch
indicator light will glow. The flame effect will be visible through the
back.
● Temperature Knob: Toggle the temperature switch
temperature control knob regulates the temperature level of the
room. The further the knob is rotated clockwise, the higher the
temperature setting. Turning the knob counterclockwise will lower
the temperature setting. Use this function to help regulate the
ambient temperature level.
● Temperature Limiting Control: This fireplace is equipped with a
temperature limiting control. Should the fireplace reach an unsafe
temperature because of misuse or accident, the fireplace will
automatically turn off. To reset: Unplug the power cord from the
outlet. Wait for 15 minutes. With the power switch in the OFF
position, plug the power cord back into the outlet.
● Always turn the fireplace OFF and unplug the power cord from the
outlet before cleaning.
● Use a vacuum or duster to remove dust and dirt from the fireplace
and vent areas.
● To keep luster, clean with a soft, slightly damp cloth and buff with a
dry cloth.
● Never use abrasive cleansers, liquid sprays, or any cleaner that
could scratch the surface of the appliance.
08
ON. The power
ON, the
Maintenance
Troubleshooting
WARNING
Disconnect power before servicing.
Problem
Possible Cause
• The fireplace is not
The fireplace
plugged in.
does not
• A circuit breaker is
operate.
tripped or a fuse
blown.
• The ON/OFF switch
is defective.
• There is loose
wiring.
The power light
• The fireplace is not
is ON but the
operating correctly.
flame effect is
not visible.
• The fireplace is not
operating correctly.
The fireplace is
• The fireplace switch
not operating.
is defective.
• The fireplace
assembly is defective.
• There is loose
wiring.
• The vents are dirty
or clogged.
There is
• The fan is defective.
excessive
• The fireplace
noise when
assembly is defective.
the fireplace
is operating.
Corrective Action
• Make sure the fireplace
is plugged in to a
standard 120V outlet.
• Check additional
appliances on the circuit;
ideally the fireplace
should be on a dedicated
15-amp circuit.
• Ask qualified technician
for help.
• Ask qualified technician
for help.
• Refer to the operating
instructions.
• Ask qualified technician
for help.
• Refer to the operating
instructions.
• Ask qualified technician
for help.
• Ask qualified technician
for help.
• Ask qualified technician
for help.
• Unplug the unit. Clear
the vent area of dust and
debris. Wait for ten
minutes, plug the unit in
again and turn on the
fireplace.
• Ask qualified technician
for help.
• Ask qualified technician
for help.
09
Publicité
