Publicité
Les langues disponibles
Les langues disponibles
Maintenance
REPLACING FILTER
If the filter needs to be changed, replace it with a similar
filter. The filter should also be replaced if it is damaged with
punctures, bends, or a broken frame
- Turn off the range hood and disconnect the power .
- Replace with an equivalent filter, then reconnect the
power .
REPLACING LIGHT BULBS
When light bulbs burn out, replace them with a A15 5W E26
base LED bulb .
- Turn off the range hood, disconnect it from its power
source, and if applicable, ensure that the lights are cool .
- Remove the light cover (1) by pressing the sides inwards .
- Turn the bulb counter-clockwise and pull it out to remove it.
- Push in the new bulb (2) and turn it clockwise . Do not
release the bulb until you are sure the bulb has been
securely installed . Then reconnect the power .
- Check that the new bulbs operate correctly and are
inserted properly .
- Reinstall light cover afterwards .
QR251SL / QR251WL
DANGER:
Turn off the power circuit breaker or the power
switch on the junction box before performing maintenance .
Touching circuitry inside the range hood while it is energized
will result in death or serious injury .
WARNING:
Failure to replace worn out or damaged filter
will increase the risk of fire.
WARNING:
Light bulbs other than LED bulbs can become
hot when turned on . Do not touch any bulbs until they are
switched off and cooled . Touching hot bulbs could cause
serious burns .
Press inwards
1
14
1
2
Publicité
