Table Des Matières; Safety Warnings; How Does Marmitek X-10 Work - Marmitek EASY TOUCH PANEL 10 Guide Utilisateur

SAFETY WARNINGS

• To prevent short circuits, this product should only be used inside and only in dry spaces. Do not expose the components
to rain or moisture. Do not use the product close to a bath, swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures or bright light sources.
• In case of improper usage or if you have altered and repaired the product yourself, all guarantees expire. Marmitek
does not accept responsibility in the case of improper usage of the product or when the product is used for purposes
other than specified. Marmitek does not accept responsibility for additional damage other than covered by the legal
product responsibility.
• This product is not a toy. Keep out of reach of children.
• The product should only be repaired or serviced by a qualified expert.
• Keep batteries out of the reach of children. Dispose of batteries as chemical waste. Never use old and new batteries or
different types of batteries together. Remove the batteries when you are not using the system for a longer period of time.
Check the polarity (+/-) of the batteries when inserting them in the product. Wrong positioning can cause an explosion.
• Automatic switching devices provide comfort, but can also be dangerous. They can surprise people or can ignite
clothing hanging over an electric heat source. Please be careful and take appropriate measures to avoid accidents.
• In order to prevent damage (e.g. scratches) do not use any sharp objects for operating this product.
TABLE OF CONTENTS

HOW DOES MARMITEK X-10 WORK? ________________________________________________________________ 1

ADRESSES _____________________________________________________________________________________ 1
SIGNAL RANGE ________________________________________________________________________________ 2
INTRODUCTION___________________________________________________________________________________ 2
HOW DOES THE EASYTOUCH PANEL 10 WORK? ______________________________________________________ 3
INSTALLATION (factory settings) _____________________________________________________________________ 3
PERSONALISING YOUR EASYTOUCH PANEL 10 ________________________________________________________ 4
BACKGROUND ___________________________________________________________________________________ 4
EASYTOUCHPANEL10 AND SAFEGUARD OR TOTALGUARD ALARM SET ___________________________________ 6
PROGRAMMING SUMMARY ________________________________________________________________________ 7
FREQENTLY ASKED QUESTIONS _____________________________________________________________________ 9
TECHNICAL DATA ________________________________________________________________________________ 10
HOW DOES MARMITEK X-10 WORK?
Marmitek X-10 components use the existing mains wiring to communicate (using Marmitek X-10 signals). You can build
a complete system using the three different kind of components of the Marmitek X-10 System:
1. Modules: These components will receive Marmitek X-10 signals and will switch or dim the attached lamp or
appliance. Examples of these modules are lamp modules and appliance modules. These are available
as build-in, micro, DIN rail and plug-in modules.
2. Controllers: These components will transmit Marmitek X-10 signals and thus will control the Modules.
3. Transmitters: Wireless components like remotes. The signals of these components will be received by a controller
with transceiver functionality (IRRF 7243, TM13 or CM15Pro). The Transceiver will translate the signals
into Marmitek X-10 signals on the power line.
ADRESSES
Up to a maximum of 256 different addresses can be preset. These are subdivided into a so-called HouseCode (A to
P incl.) and a UnitCode (1 to 16 incl.). The HouseCode can also be set on the controllers, so that the controllers and
modules become part of the same system. The address can be set either using code dials or by pressing buttons,
depending on the type of module.
The Marmitek X-10 System uses standard commands, which control all units with the same HouseCode at the same time
(e.g. all lights on, all off, etc.).
Easy Touch Panel 10™
1