VONROC S2 CD502DC Traduction De La Notice Originale page 7

TECHNICAL SPECIFICATIONS
Model No.
Charger
Input of charger
Output of charger
Rechargeable battery pack
Battery charging time
Chuck capacity
Torque settings
No load speed
Position 1:
Position 2:
Weight (incl. battery)
Sound pressure level L
PA
Sound power level L
WA
Hand-arm vibration a
h
(screwdriving without impact)
Hand-arm vibration a
h,D
(Drilling into metal)
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 62841; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
signifi cantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 3.
WWW.VONROC.COM
Fig. A
1. Machine
CD502DC / S_CD502DC
2. Battery
/ S2_CD502DC /
3. Battery unlock button
S3_CD502DC
4. Work light
CD814AA
5. Charger
6. Charger LED indicator
100-240V~ 50/60Hz
7. Chuck
Max.0.4A
8. Gear selection switch
13.5V DC 1.3A
9. Direction switch
12 V Li-ion 1.3Ah
10. On / off switch
11. Torque adjustment ring
60 minutes
1.0 - 10 mm
3. OPERATION
17 + Drill mode
0-350 /min
Removing the battery from the machine (Fig. B)
0-1300 /min
• Push the battery unlock buttons (3) and pull the
1.0 kg
66.57 dB(A), K=3dB(A)
Inserting the battery into the machine (Fig. B)
77.57 dB(A), K=3dB(A)
0.854 m/s 2 K=1.5 m/s 2
2.069 m/s 2 K=1.5 m/s 2
• Insert the battery (2) into the base of the machi-
• Push the battery further forward until it clicks
Charging the battery with the charger (Fig. C)
• Plug the charger plug into an electrical outlet and
LED indicator (6) (Fig. C)
The charger has 1 LED indicator (6) which indicates
the status of the charging process:
• Fully charging the 1.3Ah battery may take up to
• After the battery is fully charged remove the
The battery must be charged before fi rst use.
battery out of the machine like shown in Fig. B.
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
ne as shown in Fig. B.
into place.
wait for a while. The LED indicator on the charger
(6) will lighten up and show the charger status.
LED Charger status
Red Battery charging in progress
Green Battery charging fi nished, battery fully charged
60 minutes.
charger plug from the outlet and remove the
battery from the charger.
EN
7