Blaupunkt 5WK600FF0R Notice D'utilisation page 45

10. TROUBLE SHOOTING
You can solve many common wine cooler problems easily, saving you the cost of a possible service call. Try the suggestions
below to see if you can solve the problem before calling the servicer.
PROBLEM
Wine cooler does not operate
Wine cooler is not cold enough
Turns on and off frequently
The light does not work
Vibrations
The wine cooler seems to make too much noise
The door will not close properly
Failure LED display
Fans do not work anymore
« E1 » or « E2 » error code
POSSIBLE CAUSE

Not plugged in

The circuit breaker tripped or a blown fuse

Check the temperature control setting

External environment may require a higher
setting

The door is opened too often

The door is not closed completely

The door gasket does not seal properly

The room temperature is hotter than normal

A large amount of contents has been added to
the wine cooler.

The door is open too often

The door is not closed completely

The temperature control is not set correctly

The door gasket does not seal properly

Not plugged in

The circuit breaker tripped or a blown fuse

The bulb has burned out, contact your after-
sales service

The light switch is "OFF"

Check to assure that the wine cooler is level

The rattling noise may come from the flow of
the refrigerant, which is normal

As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
wine cooler

Contraction and expansion of the inside walls
may cause popping and crackling noises

The wine cooler is not level

The wine cooler is not level

The door was reversed and not properly
installed

The gasket is dirty

The shelves are out of position

Poor display quality

Temperature value does not appear

Contact your after-sales service

Contact your after-sales service

Temperature probe is failing

Contact your after-sales service