Blaupunkt 5WK600FF0R Notice D'utilisation page 40

 To select the temperature zone, press (H) once, upper zone will flash, (H) key pressing again to
switch it to lower zone. Setting temperature could only be set under display flash status.
 You can touch key "+" (C) and key "-" (B) to set the internal temperature for the selected zone. The
degrees indicators will appear in the display window marked
zone.
 When the unit is plugged in for the first time, the LED readouts will show the original temperature set
previously. Touch the "+" (C) and "-" (B) mark once of each compartment to set the desired
temperature.
 The temperature will increase by 1°C or 1ºF if you touch the "+" (C) mark once, or the temperature
will decrease by 1°C or 1ºF if you touch the "-" (B) mark once.
Temperature display
Display show at its setting.
To view the actual temperature in either zone at any time, touch key (B) and key (C) for 3 second, the
display will display two zone's actual temperature with flashing, and it will quit by holding stop.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature setting on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to
wait 5 minutes before turning it on again.
Temperature alarm
The alarm will sound and the temperature display will flash when:
- The temperature in one of the zones rises or falls outside the temperature range (5-12°C or 12-
20°C)
- You switch the appliance on, if the temperature inside the appliance is very different (+/- 4°C)
from the temperature set after 7 hours working
- Too many items have been put into the unit at one time, and the temperature inside the appliance
is very different (+/- 4°C) from the temperature set after 7 hours working
- The door has not been closed tightly
Door alarm
If the door has been left open for more than 60s, the alarm will sound. Once the set temperature has
been reached in the appliance, the alarm stops and the relevant temperature display stops flashing.
However, if the noise disturbs you, you can switch the alarm off before this if you wish by pressing the key
I once. The alarm will stop. The relevant temperature display continues to flash until the set temperature
has been reached. The display then lights up constantly and the alarm system is fully active again.
Interior light
The interior light
Touching the mark (J) toggles between two modes of operation for the internal lights:
- Functional mode (default): the light will turn on only when the door is open, this is the most
economic mode
- Showcase mode: the lights will be on whether or not the door is open. To turn this permanent light
mode and get back the default mode, please push again the light button
Dynamic climate / silent mode
Wine cellars are designed to preserve your wines in perfect conditions over long periods in complete
safety. However, no frost systems can cause noise, this is the reason why the silent mode is the default
makes it easy to view your wines labels and enhances the display of your collection.
for upper zone and
(J).
for lower