Cub Cadet BB230 Manuel De L'utilisateur page 10

WARNING:
Operate this unit only in a well-ventilated
outdoor area. Carbon monoxide exhaust fumes can be
lethal in a confined area.
WARNING:
Avoid accidentally starting the unit. To avoid
serious injury, the operator and the unit must be in a stable
position when pulling the starter rope (Fig. 9).
WARNING:
When starting the unit, make sure it is not
directed toward people, animals, windows, automobiles or
loose debris.
STARTING INSTRUCTIONS
NOTE: This unit includes a cruise control, which allows the operator
to maintain the desired engine speed without having to squeeze
the throttle control.
1. Mix gasoline with oil. Refer to Oil and Fuel Mixing Instructions.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off switch is in
the On ( I ) position at all times (Fig. 7).
3. Slowly press and release the primer bulb 10 times (Fig. 8). If fuel
cannot be seen in the primer bulb, press and release the primer
bulb until fuel is visible.
4. Move the choke lever to Position 1 (Fig. 8).
5. Move the cruise control to the HI (fast) position (Fig. 7).
NOTE: Keep the cruise control in the HI (fast) position for ALL
further steps.
6. Crouch in the starting position (Fig. 9).
7. Pull the starter rope with a controlled and steady motion 5 times
(Fig. 9).
8. Move the choke lever to Position 2 (Fig. 8).
9. Pull the starter rope with a controlled and steady motion 3 to 5
times to start the engine.
10. Allow the engine to warm up for 30 to 60 seconds.
11. Move the choke lever to Position 3 (Fig. 8). Allow the engine to
warm up for an additional 60 seconds. The unit may be used
during this time.
NOTE: The engine is properly warmed up when it accelerates
without hesitation.
NOTE: Once the engine is properly warmed, the cruise control may
be adjusted and the throttle control can be used normally.
12. Put on the harness. Refer to Using the Harness.
IF... the engine hesitates, return the choke lever to Position 2 (Fig. 8)
and continue the warm-up.
IF... the engine does not start, begin the starting procedure with step 3.
IF... the engine fails to start after a few attempts: Move the choke
lever to Position 3. Move the cruise control to the HI (fast)
position. Pull the starter rope with a controlled and steady
motion until the unit starts.
IF... the engine is already warm, begin the starting procedure with
step 7.
STARTING AND STOPPING
Choke Lever
STOPPING INSTRUCTIONS
1. Release the throttle control, or move the cruise control to the LO
(slow) position, and allow the engine to idle.
2. Press and hold the On/Off switch in the Off (O) position until the
engine comes to a complete stop (Fig. 7).
10
LO (slow)
Cruise Control
HI (fast)
Throttle Control
Fig. 7
1 2 3
Position 1 Position 2
Fig. 8
Starter Rope Grip
Fig. 9
On/Off Switch
(I = On / O = Off)
Primer Bulb
Position 3
Starting
Position