PENTA Intelliboost MIB0715B Manuel D'utilisation page 9

LINE
a)
RUN
FAULT
MODE
LINE
RUN
MODE
SET
ESC
LINE
60 PSI
RUN
b)
FAULT
MODE
Figure 6
3. Pressure level setting (set-point)
To increase or decrease the set-point,
press the up or down
(See Figures 7 and 8).
+
LINE
4
SET
RUN
FAULT
MODE
Figure 7
Figure 8
QUICK TROUBLESHOOTING
GUIDE
buttons
Removal
1. Disconnect the power supply and
PSI
2. Disconnect the VFD from the power
3. Close the shutoff valves on the
SET
ESC
4. Loosen the fill cap to relieve the
5. Remove the drain plug from the
9
-
LINE
2
PSI
SET
RUN
FAULT
MODE
wait at least 5 minutes for the VFD
capacitors to discharge. Before
starting work, the LED "LINE"
must be OFF. Make sure that the
power supply cannot be restored
accidentally.
supply at the circuit breaker.
delivery and suction sides of the
pump. Notice the position of the fill
port, which can also be used as a
bleed point. Make sure that draining
the pump cannot cause damage or
physical injury.
pressure of the water remaining in
the pump (between the two pump
shutoff valves).
pump body to completely empty the
pump.
SET
ESC