Westfalia 84 36 70 Mode D'emploi page 23

Speed Controller
With the speed controller (9) you can adjust the speed. The required rotation
speed depends on the material being processed and the used sanding paper.
It is best selected by a practical test.
Attention: Do not run the belt sander in continuous operation with low speed.
This will overheat the motor.
You can also adjust the speed during operation.
Stationary Sanding
The fixed mounting kit allows you to use the
machine for sanding vertically by fastening it
on to a flat stable surface (e.g. workbench).
Insert the clamps (13) into the openings (11)
and attach the sander to a suitable surface with
the belt facing up.
Cleaning
Always disconnect the belt sander from the mains before cleaning!

Clean the machine of sanding dust and other particles after each use,
using a hand-brush or a cloth.

In particular, the ventilation slots in the motor housing must be cleaned
regularly. If these become blocked the motor may overheat.

Do not clean the machine with aggressive detergents or aggressive chem-
icals.

If the central air duct is clogged up, remove the cover (17) with a small
screwdriver and carefully clean the duct.
Operation
19