Gewiss Chorus GW 90 836A Mode D'emploi page 22

PROGRAMMING WITH THE EASY CONFIGURATOR
Initialisation with the Easy base unit (GW 90 831)
1. Power the device via the bus.
2. Follow one of these procedures for the system to acquire the device:
• Automatic acquisition (the device still has the factory default settings):
- choose the "New Function Application"
menu from the Easy base unit: the device is recognised automatically.
• Manual acquisition (factory default settings have been changed):
- choose the "Find Device Application"
- press the programming key briefly (< 2 seconds). The programming LED turns on
during the acquisition process (figure A).
The device acquired by the Easy base unit is listed, with the number assigned to it, in the
channels of the "New Function
Programme the actuator with the Easy controller (GW 90 837 / GW 90 838 / GW 90 840)
or with the Easy base unit (GW 90 831).
Each output to programme can be selected as wanted:
• pressing the local command push-button: this channel will then be highlighted on the
list of channels;
• directly from the list of channels.
The functions can be created once the devices have been selected.
Name of the functions
toggle
edges
timer mode
priority control
scene
switch-on time
prewarning time
For more details about the programming procedures please refer to the Easy base unit
or Easy Controller documentation.
Application" or "Edit Function
load activation or deactivation
load activation or deactivation
load activation with timer
actuation of the priority commands
actuation of the scenes
22
or the "Edit Function
from the Easy Base unit;
Application" menu.
Application"