Publicité
Les langues disponibles
Les langues disponibles
Amplifier Owner's Manual
INPUT
Connect preamp signal cables from the head unit to these terminals.
CROSSOVER FREQUENCY
Controls the lowpass crossover point for the speaker outputs.
BASS BOOST
Variable bass boost from 0 to +18dB @ 45Hz.
REMOTE LEVEL CONTROL
This port is for connecting the subwoofer remote level control. This allows
up to 20dB of volume adjustment. This is not a bass boost, it controls the
level of the low pass signal.
NOTE: This control is not compatible with the Phoenix Gold LPL44 level
control.
SPEAKER
GROU ND
GROUND
+12V
This must be connected to the fused positive terminal (+12V) of the car's
battery. The fuse must be located within 18 inches of the battery.
REMOTE
PROTECT
REMOTE
This must be connected to switched +12V, usually a trigger wire coming
from the head unit or ignition.
GROUND
This must be connected to the negative terminal of the car's battery or
POWER
bolted to a clean, unpainted part of the chassis of the vehicle.
NOTE: Visible through the plexiglass cover, a single blue power LED is located in the lower corner of all SD amplifiers.
GROU ND
All manuals and user guides at all-guides.com
Monoblock Power Amplifier
REMOTE
PROTECT
POWER
R
+ 12V
REMOTE
+ 12V
SUB INPUT
L
SUB INPUT
SENS
S UB
FRONT
MIN
R
SENS
HPF
15Hz
250Hz
MIN
R
+ 12V
SENS
Used to reach maximum amplifier power with a wide variety of headunits.
SUBSONIC CROSSOVER FREQUENCY
Controls the highpass crossover point for the speaker outputs to eliminate
extreme low frequencies.
RMD
Optional RMD Voltage Display plugs into this port. Sold separately.
RMD
X-OVER
FREQ.
BASS
30Hz
300Hz
0dB
18dB
FUSE
40A
40A
40A
FRONT
SPEAKER OUTPUTS
FL
Used to connect the amplifier to speakers. SD1300.1 minimum impedance
LPF
BASS BOOST
is 1 ohm.
MAX
0dB
18dB
30Hz
300Hz
SENS
HPF
FR
MAX
15Hz
250Hz
MIN
MAX
FL
SD1300.1
INPUT
SUBSONIC
SENS
10Hz
55Hz
MIN
MAX
INPUT
REAR
RL
RMD
RR
FR
SUB.
© 2011 Phoenix Gold • www.phoenixgold.com
L
R
Publicité
