3.
General Guidelines
•
Refer to the Velleman
manual.
•
All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
•
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.
•
Keep this manual for future reference.
4.
Use
Installation
Install the appliance on a flat, non-slippery surface.
Charging
The speaker is powered by a built-in rechargeable battery, which must be fully charged
before first use. To do so, connect the appliance to a powered USB power source using
the included USB cable.
The charge LED on the display will burn red. When the battery is fully charged, the LED
will switch off.
Note that a rechargeable battery has a limited number of charge cycles. Battery life and
number of charge cycles vary according to use and settings.
Average charging time is 2 hours. To prolong battery life, do not charge continuously for
more than 2 hours.
On/Off
1.
To switch on the appliance, turn the power knob to the on position. The appliance
will enter the last used mode before switch-off.
2.
To switch off the appliance, turn the power knob to the off position.
Wireless Function
1.
Press the mode button to select the wireless function. The speaker will beep twice.
2.
Activate the wireless function on your mobile phone and search for the appliance
SA1040. Pair the appliance to your phone. Enter password 0000 if necessary.
3.
You can now play music files from your mobile phone. Control the track from your
mobile phone and adjust the volume level with the volume knob on the appliance
or mobile phone.
USB/TF Card
1.
Insert a USB stick into the USB port, or a TF card in the TF port. The audio files will
play automatically.
2.
Play/pause the track with the play/pause button. Select the previous/next track by
briefly pressing the previous/next button. Adjust the volume level with the volume
knob.
V. 02 – 23/12/2019
HQSA1040
®
Service and Quality Warranty on the last pages of this
3
©Velleman nv