Porter & Charles F65478VI-S Mode D'emploi page 10

USER INSTRUCTIONS
2.2.4 Interrupting a program
To interrupt the current program simply open the door of the dishwasher; to
restart the program, simply close the door again. The program restarts from
where it was interrupted.
If it is necessary to open the door during the washing cycle, the
program will be interrupted, the relative indicator light will continue to
fl ash and a beep will indicate that the cycle has not terminated. Wait
for about 1 minute before closing the door and continuing with the
program. When the door closes, the program will start from where it
was interrupted. This operation should be performed only if neces-
sary as it could cause irregular program performance.
2.2.5 Changing the current program
To change the current program, simply open the door of the dishwasher and
select the new program. Close the door to run the new program automatically.
2.2.6 Canceling the current program
• To cancel the current program, open the door and press and hold down the
program selection button (ref. 3 fi g. 2-02) for a few seconds until the indi-
cator lights of the fourth and fi fth programs turn on (ref. pr. 4, pr. 5 fi g. 2-03).
• Close the door again.
• After about 1 minute, the dishwasher terminates the cycle and the indicator
lights of the fourth and fi fth programs (ref. pr. 4, pr. 5 fi g. 2-03) start fl ashing.
Rev 0.0
pr. 4 pr. 5
EN
Fig. 2-03
9