Ferm Industrial HDM1042P Traduction De La Notice Originale page 4

Use of extension leads
Only ever use approved extension leads that are
suitable for the power rating of the machine. The
minimum core thickness is 1.5 mm
using a reel extension lead, always fully unroll the
lead.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes.
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.
2. MACHINE INFORMATION
Intended use
The demolition hammer is intended for
demolishing concrete, chiseling off concrete,
grooving and bar cutting.
This machine can only be used with
30 mm SDS-Hex chisels.
Technical specifications
Mains voltage
Mains frequency
Power input
Impact rate
Impact energy
Weight
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration
Main grip a
h,Cheq
Auxiliary grip a
h,Cheq
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in
EN60745. It may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
4
• Using the tool for different applications, or with
2 . Whenever • The times when the tool is switched off or when
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2
Fig. A & B
1. On/off switch
2. Main grip
3. Auxiliary grip
4. Locking pin
5. Tool holder
3. ASSEMBLY
230 V ~
50 Hz
1.500 W
Mounting and removing the accessory
1.400/min
Fig. B
50J
15.6 kg
83.88dB(A) K=3 dB(A)
Mounting
105dB(A) K=3 dB(A)
• Apply a few drops of oil into the shaft of the
19.67 m/s 2 K=1.5m/s 2
• Pull out the locking pin (4) and turn the locking
2 2
15.26 m/s K=1.5m/s
• Insert the accessory into the tool holder (5): the
• Pull out the locking pin (4) and turn the locking
different or poorly maintained accessories,
may significantly increase the exposure level.
it is running but not actually doing the job, may
significantly reduce the exposure level.
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Do not use blunt drill bits or chisels.
Immediately sharpen or replace blunt
drill bits or chisels.
accessory.
pin (4) 180° clockwise or anticlockwise.
flat side of the accessory towards the side of
the locking pin.
pin (4) 180° clockwise or anticlockwise to lock
the accessory.