Publicité
Les langues disponibles
Les langues disponibles
EN
FREQUENTLY ASKED QUESTIONS
Why does water come out of the nozzle?
Steamer generates a large amount of steam that can condense in
water in the hose and extension tubes after a period of no use or
cooling of the unit. Empty this water by operating the steam trigger
over a bucket or sink. Once this water has drained, you can use your
device normally.
No Steam Is Coming Out?
Check that the hose is not bent or bent and, if necessary, retension.
Make sure that the water tank is not empty.
I cannot remove the fill cap?
Make sure the Steamer is completely depressurized. The filler cap is
designed so that it can not be removed while the unit is still under
pressure. To do this, empty all residual pressure from the tank by
pressing the steam trigger (2). The steam trigger can be unlocked by
engaging the steam trigger lock latch (3) in the ON position. Once
the pressure is discharged from the tank, the filler cap of the tank
can be opened.
The steam flow is irregular, the appliance "coughs".
Slight blockage caused by soil or other foreign matter that can
prevent the flow of steam from arriving continuously. Clean the
water tank as shown on page 33.
I see the condensed water on the gauge of the manometer (6)?
Any condensation that may appear will disappear in a short period
of time. No action is necessary.
Can I use boiled water from my tea kettle?
No. Boiled water concentrates the minerals that form the tartar.
Never use pre-soaked water in Steamer.
1 3
Publicité
