Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL REQUIREMENTS
If codes permit and a separate ground wire is used, it is recommended
adequate and wire gauge is in accordance with local codes.
Do not use an extension cord.
IN U.S.A. :
Be sure that the electrical connection and wire size are adequate and
in conformance with the National Electrical Code, ANSI/ NFPA No.
70-latest edition and all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269
IN CANADA:
Be sure that the electrical connection and wire size are adequate
and in conformance with CSA standard C22.1, Canadian Electrical
Code, Part 1 - latest edition, and all local codes and ordinances.
A copy of the above code standards can be obtained from:
Canadian Standards Association
178 Rexdale Blvd.
Toronto, ON M9W 1R3 CANADA.
WARNING
ELECTRICAL SHOCK HAZARD
The electrical power to the oven branch circuit must be shut off
while line connections are being made.
Do not use an extension cord with this appliance.
Electrical ground is required on this appliance. The free end
of the green wire (the ground wire) must be connected to a
suitable ground. This wire must remain grounded to the oven.
If cold water pipe is interrupted by plastic, non metallic gaskets,
union connections or other insulating materials, DO NOT use
for grounding.
DO NOT ground to a gas pipe.
DO NOT have a fuse in the NEUTRAL or GROUNDING
circuit. A fuse in the NEUTRAL or GROUNDING circuit
could result in an electrical shock.
whether the appliance is properly grounded.
ELECTRICAL CONNECTION
To properly install your oven, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
• Oven must be connected to the proper electrical voltage and
The model/serial number rating plate is located under the control
panel on single ovens and under the control panel on the upper oven
cavity on double ovens. All models are dual rated, and designed
to be connected to 120/240V AC, 60Hz, 3-wire or 4-wire, single-
phase power supply.
VOLTAGE AND
STYLE
FREQUENCY
Single Oven
240V, 60 Hz
Double Oven
240V, 60 Hz
• Install a suitable conduit box (not furnished). An appropriately
sized, UL conduit connector must be used to correctly attach the
conduit to the junction box.
IMPORTANT: Local Codes may vary; installation electrical
connections and grounding must comply with all applicable
local codes.
If local codes permit grounding through the electrical supply neutral,
connect both the white neutral wire and the green ground wire from
the oven to the white neutral electrical supply wire.
•
oven is properly grounded.
• Single Oven - When a 4-wire, single phase 120/240 volt, 60 Hz.,
AC only electrical supply is available, a 25-amp maximum circuit
protection is required.
• Double Oven - When a 4-wire, single phase 120/240 volt, 60 Hz.,
AC only electrical supply is available, a 40-amp maximum circuit
protection is required.
5
AMPS
CIRCUIT REQUIRED
20.0A
25 Amp Circuit
35.4A
40 Amp Circuit
E
Publicité
