Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools before starting installation. Read and
follow the instructions provided with any tools listed here.
ALL INSTALLATIONS
TOOLS NEEDED:
• Measuring Tape
• Straightedge
• Pencil
• Phillips Screwdriver
• Level
• Wire Cutters and Wire Stripper
• Hand or Sabre Saw
• 1" Hole Saw
• Cordless Drill and Drill Bit
• Safety Gloves and Goggles
• Volt Meter (0-250VAC)
PARTS NEEDED:
• UL Listed Conduit Connector
• UL Listed Wire Connectors
PARTS PROVIDED:
• #8-14 x 1" Screws - Single Ovens (2), Double Ovens (4)
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow
the safety alert symbol and either the work "DANGER", "WARNING" or "CAUTION".
DANGER
WARNING
CAUTION
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what
can happen if the instructions are not followed.
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to the State of California to cause cancer.
WARNING: This product contains one or more chemicals known to the State of California to cause birth defects or other
reproductive harm.
YOUR SAFETY AND THE SAFETY OF OTHERS ARE VERY IMPORTANT.
An imminently hazardous situation. You could be killed or seriously injured if you don't
immediately follow instructions.
A potentially hazardous situation which, if not avoided, could result in death or serious
bodily injury.
A potentially hazardous situation which, if not avoided, may result in moderate or minor
injury.
LOCATION REQUIREMENTS
IMPORTANT: Observe all governing codes and ordinances.
• Cabinet opening dimensions that are shown must be used. Given
dimensions provide minimum clearance with oven.
• Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
•
bottom of the cabinet cutout.
THE OVEN SUPPORT SURFACE MUST BE ABLE TO
SUPPORT THE WEIGHT OF:
Single Oven: 130 lbs (59 kg) plus 30 lb (14 kg) food load
Double Oven: 230 lbs (105 kg) plus 60 lb (28 kg) food load
• Grounded electrical supply is required. See "Electrical Require-
ments" section.
NOTE: For undercounter installation, it is recommended that
the junction box be located in the adjacent right or left cabinet.
IMPORTANT: To avoid damage to your cabinets, check with your
builder or cabinet supplier to make sure that the materials used
will not discolor, delaminate or sustain other damage. This oven
has been designed in accordance with the requirements of UL and
CSA International and complies with the maximum allowable wood
cabinet temperatures of 194°F (90°C).
2
Publicité
