Care & Maintenance; Lubrication - Spotlight 645624 Notice D'utilisation Et D'entretien

2/ Using the Jockey Wheel:
Once the clamp has been fitted, position the jockey wheel in the
clamp (Fig a.) then fasten by rotating the clamp handle clockwise.
b.)
To lower the jockey wheel, turn the top handle clockwise.
To raise the jockey wheel, turn the top handle anticlockwise.
CARE/MAINTENANCE
1/ Galvanised Parts:
It is important to regularly clean your jockey wheel, and the frequency of which will vary depending on the wheel's use.
Galvanisation can deteriorate when exposed to acids, saline environments and certain chemicals. The jockey wheel will therefore
need to be carefully and regularly cleaned using clear water, especially during the winter months.
It is not uncommon for white, powdery stains to appear. These do not in any way affect the protective effect of the galvanisation.
After a short period, the galvanised components will develop a matte effect and a rough surface. This is completely normal and
helps to ensure optimal levels of protection against corrosion.
Oxidization may appear along the edge of some of the galvanised steel components, which is also normal and does not affect the
technical properties of your jockey wheel.
2)

Lubrication:

To ensure that the jockey wheel functions correctly, it must be well greased at all times. Please follow the steps
- Remove the jockey wheel by rotating the top handle until the two parts of the tube are completely separated and the screw
axis is accessible. (Fig a.)
- Remove the grease that has become dry and dark-coloured inside the screw axis.
- Clean with white spirit.
- Fill with the new grease.
- Reassemble the jockey wheel.
Fig a
(Fig b.)
(Fig c.)
Fig b
(Fig
Fig a
(Fig 1.)
(Fig 2.)
Fig 1
Fig c
Fig b
Fig 2
below: