Safety Instructions - Spotlight 645624 Notice D'utilisation Et D'entretien

GB
IMPORTANT: Please read these instructions carefully prior to use.
FEATURES
Static Load Capacity
Weight
Minimum Height
Maximum Height
Tube Thickness
Surface treatment
Rim
Width of wheel

SAFETY INSTRUCTIONS

1/ This jockey wheel is not designed to withstand heavy loads and must not under any circumstances be used while a trailer
is loaded.
2/ It is important to avoid overloading a trailer as it can cause considerable damage:
- Front overload: breakage of the drawbar or tow bar
- General overload: Burst tyres, breakage of the drawbar and axle, deformation of the side members and the frame, poor braking,
premature wear of the bearings.
- Rear overload: swaying or jack-knifing.
3/ Check that screws are correctly fastened before each use.
4/ Check that the jockey wheel functions correctly by rotating it 360°. If required, apply grease to the rod.
5/ If fitted to a trailer that is being towed by a vehicle, the jockey wheel might get pulled off or projected. Therefore, for safety
reasons, when the trailer is coupled to a vehicle or when loaded, the jockey wheel should be removed from its support.
6/ If fitted to a trailer that is being towed by a vehicle, a jockey wheel that has not been correctly positioned can obstruct the
trailer's braking system. Therefore, before each journey, it is essential to check that the brake linkage is not obstructed by the
jockey wheel. This means ensuring that the jockey wheel is parallel to the brake linkage.
7/ Ensure that the maximum static load capacity has not been exceeded.
8/ This jockey wheel is suitable for trailers with a maximum GVWR of 800 kg.
9/ We cannot be held responsible for any personal injury or physical damage resulting from failure to comply with these instructions.
INSTRUCTIONS FOR USE
This jockey wheel is designed for the following applications:
- Coupling and uncoupling a trailer
- Moving an empty trailer
- Supporting an empty trailer
1/ Fitting the Clamp (not include)
The clamp is fixed via the pre-drilled holes on the drawbar or frame of your trailer.
Align the holes of the clamp with the pre-drilled holes on your trailer, then fasten with 2
M10x20 screws, 2 nuts and 2 washers.
Max 250kg
7 kg
520 mm
770 mm
3 mm
galvanized
steel
60 mm
120 mm
Ø 60 mm
380 mm
Ø 200 mm