LevelOne PLI-3411 Guide D'installation Rapide page 4

English
Hardware Installation
Ethernet Cable (RJ-45)
Powerline
Room 1
Notebook
Front Panel LEDs
On
Normal Operation
The Powerline network is active.
This means that at least one
other HomePlug Device was
detected.
Ethernet connection is active
Wireless connection is active
WPS connection is active
Configuration requires the use of Windows PC. Once configured, any device may be connected to the 200Mbps
HomePlug AV Adapter's Ethernet port. To perform configuration, follow the procedures list below.
1. Connect a RJ-45 Ethernet cable from the 200Mbps HomePlug AV Adapter's Ethernet port to your PC.
2. Connect a RJ-45 Ethernet cable from your xDSL/Cable Modem's Ethernet port to the other Powerline Ethernet
Adapter's LAN Ports.
3. Plug the200Mbps HomePlug AV Adapter into a power outlet.
4. Wait a few seconds for start-up to be completed, and then check the LEDs.

The

The LED will be ON if other HomePlug devices are detected, otherwise it will be OFF.
All manuals and user guides at all-guides.com
PC
Data is being transmitted or
received via the Powerline
Data is being transmitted or
received via the Ethernet Port.
Data is being transmitted or
received via the Wireless.
Data is being transmitted or
received via the WPS
LED should be ON.
Room 2
ADSL / Cable Modem
Flash
NA
Powerline network is not available
- no other HomePlug devices were
network.
- 3 -
Internet
Off
No Power
detected.
No Ethernet connection
No Wireless connection
No WPS connection