Publicité
Add Detergent, Close the Door and Set the Program
Load the clothes to be washed in the drum and close the door.
Add the detergent into the relevant compartments for the type
of program you are going to select, Add detergent as described
in Detergent and Additives section of User's Operation
Manual.
1.Turn on the power.
2.
Spin program selection button to required program, "off"
must be passed through if pointer's initial position is
not "off ",start up.
3.Select washing temperature, spin speed by pressing "Temp",
"Spin" buttons.
4.Press "Options" button to select additional functions.
5.After starting the program, display window displays program
length (hours: minutes) and additional function options in sequence.
Addition function selection
At standby state, press "Options" button to select additional
function for current program. Select only one function for each
press, and then corresponding icon flashes. After starting up,
program cannot be changed.
Pre-wash
·Select the function to conduct pre-wash so as to enhance washing
effects and better remove stains. This function is suitable for
heavy dirt clothes.
·Before inflowing, laundry detergent/ washing powder can be
added to pre-wash box, and washing powder must be added to
main wash box.
Extra Rinse
·
rinsing process once again before running the softening, and
EVWDC91460AW
66
133
Inlet water warning
If tap is not opened, or water pressure is over low,and display
screen will prompt "F01" to give alarm.
Drainage warning
If the pipe is squeezed, drainage will not be smooth. In case of
failing to completely drain for long time, display screen will
prompt "F03" to give alarm.
Door Lock Icon
After the program starts the Door Lock icon will light up and
the door will be locked.
·After completing program, door lock unlocks automatically.
During pause, if door opening condition can be met halfway,
the door lock will unlock and its indicator light will go out.
·When door lock indicator light flashes, door shall not be opened
forcibly so as to avoid personal injury.
Delay End Function
Delay End function allows to run the machine at the consumers'
convenience, for example, at night when electricity is cheaper.
•Only under the standby mode, this button is valid for
selecting the reservation time.
•After the reservation function is selected, the time will
increase 1h when each time the reservation button is pressed.
Before reservation, if the program time does not satisfy the
integral multiple of 1h, it shall be completed by pressing the
reservation key for the first time, and then the time increases
1h when each time the reservation button is pressed. If the
reservation is selected, before the program runs, the current
reservation can be canceled by turning the button to select
other programs.
•The delay time must be longer than the wash program length
as the delay time is the time program will finish. For example:
if the selected program time is 02:28, the delay time selected
must be between 03:00 and 24:00.
•When the reservation process is operated, the icon of
'reservation time' will be on. When the reservation process
is finished, the icon of 'reservation time' will be off.
•
If delay end is selected and start button is not pressed, delay can
be canceled by rotating rotary knob before starting.
•To cancel the delay time during the delay program, you need
turn the machine off by pressing "On/Off" button for 2 seconds.
Mute Function
When the machine is in the state of holding, pause or
operation, press "Spin+ Options" buttons for 2 seconds, The
display will show "bEEp oFF" . All the buzzing will be
turned off except the alarms.
When the machine is in the mute state, press "Spin+ Options"
buttons for 2 seconds until "bEEp on" appears. All the buzzing
will be activated.
Publicité
