Publicité
Les langues disponibles
Les langues disponibles
WARNING: To avoid risk of tank failure during use, drain tank after each
use or every four (4) operating hours to prevent condensation build up and
corrosion inside tanks. To drain tank, slowly and carefully turn and open drain
fittings, tip unit towards drain, and allow water to drain out.
NOTE: When draining tank, watch for debris (rust particles). If there appears to
be debris in the water, contact your dealer for possible tank replacement.
WARNING: Do not weld on the air tanks of this compressor. Welding on the
air compressor tank can severely impair tank strength and cause an extremely
hazardous condition. Welding on the tank in any manner will void the warranty. If
warranty service or repairs are needed contact your nearest authorized service
center. If one does not exist contact the factory. Unauthorized service of the
unit will void the factory warranty.
MAINTENANCE
AIR FILTER - COMPRESSORS
Inspect compressor air filters regularly. Clean filter with soap and water as
necessary. If filter becomes clogged or damaged, replace it.
WARNING: Never clean air filter with a flammable liquid or solvent.
Explosive vapors may accumulate in the air tank and cause an explosion,
resulting in serious injury or death.
CAUTION: Do not operate air compressor without air filter.
CONTROL VALVE
The control valve is preset at the factory to load at 115 psi and unload at 135
psi and should not require adjustment. If adjustment is necessary the unload
pressure is adjusted by slightly turning the pressure adjusting nut (9/16"
Hex) while holding the locking nut (5/8" Hex). Turn clockwise to increase, and
counterclockwise to decrease the unload pressure. Changing the differential (the
difference between the load and unload pressure) is accomplished by holding
the locknut (7/8" Hex) closest to the body of the valve (so it does not move)
then turning the (3/4" Hex) nut next to it very slightly clockwise to increase the
differential, and counterclockwise to decrease it.
ENGINE
Refer to engine owner's manual for proper maintenance procedures.
CAUTION: Disconnect spark plug wire before servicing engine or
compressors.
ENGINE WARRANTY AND REPAIRS
Engine adjustments, repairs, and warranty service are to be handled through
your engine manufacturer's authorized service centers. They are listed in your
telephone book yellow pages under "ENGINES, GASOLINE".
All manuals and user guides at all-guides.com
5
Publicité
