Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
ON/OFF Indicator: This symbol appears when the unit is turned
3
on by the remote controller, and disappear when the unit is
turned off.
OPERATION MODE Indicator: When press the MODE button,
4
it shows the current operating mode -- AUTO
HEAT (Cooling only model without)
LOCK Indicator: LOCK display is displayed by pushing the
5
LOCK button. Push the LOCK button to clear display.
TIMER DISPLAY Indicator: This display area shows the settings
6
of the TIMER. That is, if only the starting time of operation is set,
it will display the TIMER ON. If only the turning off time of operation
is set, it will display the TIMER OFF. If both operations are set,
it will show TIMER ON-OFF which indicates you have chosen
to set both the starting time and off time.
7
FAN SPEED Indicator: Press the FAN SPEED button to select
the desired fan speed setting (Auto-Low-Med-High). You selection
will be displayed in the LCD window except the Auto fan speed.
NOTE: All signs shown in the Fig.2 is for the purpose of clear
presentation. But during the actual operation only the re-
lative functional signs are shown on the display panel.
Operating the Remote Controller
Install/Replace Batteries
The Remote Controller uses two alkaline dry batteries
1. To install the batteries, slide the back cover of the battery
compartment and install the batteries according the
direction (+and -)shown on the Remote Controller.
2. To replace the old batteries, use the same method as
mentioned above.
NOTE
1. When replacing batteries, do not use old batteries or a different
type battery. This may cause the remote control to malfunction.
2. If you do not use the remote controller for several weeks
remove the batteries. Otherwise battery leakage may damage
the remote controller.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no answering beep from the
indoor unit or if the Transmission Indicator light fails to light.
5. Do not dispose batteries as unsorted municipal waste. Collection
of such waste separately for special treatment is necessary.
4
AUTOMATIC OPERATION
Switch on the power and the OPERATION indication lamp on the
display panel of the indoor unit starts flashing, and turns off after
flashes for 6 times.
COOL
DRY
1. Use the MODE button to select AUTO.
mode.
2. Push the TEMP button to set the desired temperature within
a range of 62 F ~ 86 F.
3. Push the ON/OFF button to start the air conditioner. The OPE-
RATION lamp on the display panel of the indoor unit lights. The
FAN SPEED is automatically set and there are no fan speed
indicators shown on the display panel of the remote controller.
4. Push the ON/OFF button again to stop the unit operation.
NOTE
1. In the AUTO mode, the air conditioner can logically choose
the mode of COOL, FAN and HEAT by sensing the difference
between the actual ambient room temperature and the set
temperature on the remote controller.
2. If the AUTO mode is not comfortable for you, the desired
mode can be selected manually.
COOL/ HEAT (Cooling only model without) and
FAN Operation
1. If the AUTO mode is not comfortable, you may manually over-ride
(LR03X2).
the settings by using COOL, HEAT or FAN modes.
2. Push the TEMP button to set the desired temperature within
a range of 62 F ~ 86 F.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH,
MED or LOW.
4. Push the ON/OFF button, the operation lamp lights and the air
conditioner start to operate as your settings. Push the ON/OFF
button again to stop this unit operation.
NOTE
The FAN mode can not be used to control the temperature.
While in this mode, only steps 1 3 and 4 may be performed.
O
O
O
O
5
Publicité
