Publicité
Les langues disponibles
Les langues disponibles
WARNING:
1.
This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of electric shock, this plug is intended to fit in a polarized outlet only one
If plug does not fit fully in the outlet, reverse plug. If it still does not fit, contact
qualified electrician to have a polarized outlet installed. Do not attempt to defeat
safety feature.
2.
Do not leave the fan running unattended.
3.
The remote control must only be used with this fan
RULES FOR SAFE OPERATION:
1.
Fan should be used under rated voltage.
2.
Connect power only after the fan is fully assembled.
3.
Never insert fingers, pencils, or any other objects through the grille when the fan is
running.
4.
Unplug fan before cleaning or moving.
5.
Unplug the fan when removing grilles for cleaning.
6.
Be sure the fan is on a stable surface when operating to prevent the fan from
tipping over.
7.
DO NOT use the fan in window. Rain may create electrical hazard.
Parts of the fan:
6629029
F-1671
All manuals and user guides at all-guides.com
way.
a
ASSEMBLY INSTRUCTIONS
this
1)
Mount the base tube to the round base and
secure by base lock collar (Fig 1)
2)
Pull the extension pole inside the large base
tube up
control collar.
3) Place the motor assembly with switch on top of
small extension pole and secure with setting
screw (Fig 2).
4) Remove the fan blade cap on the end of motor
shaft by turning clockwise and rear grill set nut
motor housing by turning counterclockwise
5) Remove the plastic sleeve around motor shaft.
6) Set the rear grill in the proper position with the
handle up and secure the rear grill by grill lock
nut tightly to attach motor housing.
7) Install fan blade on the shaft until it reaches
the retaining pin and tighten the fan blade cap
counterclockwise.
8) Mount the front guard in the proper direction
and fix both guards together with clips
OPERATING INSTRUCTIONS
1)
Place the fan on a safe, flat surface where it will not fall or be pulled by the cord.
2)
To adjust height, loosen the Height Adjustment Control Collar; adjust to the desired height
and retighten.
3)
Control the direction of the airflow by firmly holding the switch box in one hand and pushing
the fan grill back to tilt up or by pushing it forward to tilt down.
4)
To make the fan oscillate, push down on the oscillating knob located on the top of the motor
housing. To stop the fan from oscillating, pull up on the oscillating knob.
5)
Plug into an electrical outlet (120V AC, 60Hz).
.
and tighten the height adjustment
on
2
Publicité
