Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
TROUBLE SHOOTING GUIDE
PROBLEM
Pressure washer not plugged in.
Motor will
not start and
"RESET" button on GFCI not
there is no
pushed.
humming
Circuit breaker has tripped or fuse
sound
is blown.
Power
Too much load already on circuit.
source circuit
continues to
trip or blow
fuses
Motor hums
Using an extension cord.
but will not
start
Pump is stuck due to dirt, mineral
build up, or ice.
Wand not in high pressure.
No or low
pressure
(initial use)
Low water supply.
Leak at high pressure hose.
Nozzle obstructed.
Water filter screen clogged.
Defective E-Z start valve.
Air in hose.
High pressure hose is too long.
CAUSE
17 - ENG
CORRECTION
Plug in pressure washer.
Push "RESET" button.
Reset breaker or replace fuse.
Reduce load on circuit.
Try another 15 amp circuit.
DO NOT use extension cords.
Unplug unit. If temperature is
below freezing do not use. Thaw
in a warm area.
See How to Use Wand paragraph
in the Operation Section.
Water supply must be at least 5
GPM @ 20 PSI.
Repair leak. Apply sealant tape
if necessary.
Clean nozzle with paper clip or
noz zle clean ing tool, pour water
into noz zle end to flush out
ob struc tion.
Remove and clean filter.
Check with Authorized Warranty
Service Center (AWSC.)
Turn off the motor, then the
water source. Disconnect the
water source from the pump
inlet and turn the water source
on to remove all air from the
hose. When there is a steady
stream of water present, turn
water source off. Re con nect
water source to pump inlet and
turn on wa ter source. Squeeze
trigger to re move re main ing air.
Use high pressure hose under
100 feet.
A17914
Publicité
