Worx WT300K Mode D'emploi page 2

SAFETY INSTRUCTIONS
WARNING! Read and understand all instructions. Failure to follow all instructions
listed below, may result in electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
1. WORK AREA
a) Keep your work area clean and well lit. Cluttered benches and dark areas invite ac-
cidents.
b) Do not operate power tools in explosive atmospheres, such as in the presence
of flammable liquids, gases or dusts. Power tools create sparks which may ignite the
dust or fumes.
c) Keep by-standers, children, and visitors away while operating a power tool. Dis-
tractions can cause you to lose control.
2. ELECTRICAL SAFETY
a) Double Insulated tools are equipped with a polarized plug (one blade is wider
than the other.) This plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install a polarized outlet. Do not change the plug in any
way. Double Insulation eliminates the need for the three wire grounded power cord and
grounded power supply system. Before plugging in the tool, be certain the outlet voltage
supplied is within the voltage marked on the nameplate. Do not use "AC only" rated tools
with a DC power supply.
b) Avoid body contact with grounded surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric shock if your body is grounded. If op-
erating the power tool in damp locations is unavoidable, a Ground Fault Circuit Interrupter
must be used to supply the power to your tool. Electrician's rubber gloves and footwear
02
will further enhance your personal safety.
c) Don't expose power tools to rain or wet conditions. Water entering a power tool will
increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord to carry the tools or pull the plug
from an outlet. Keep cord away from heat, oil, sharp edges or moving parts. Re-
place damaged cords immediately. Damaged cords increase the risk of electric shock.
e) When operating a power tool outside, use an outdoor extension cord marked
"W-A" or "W". These cords are rated for outdoor use and reduce the risk of electric
shock. Refer to the "Recommended sizes of Extension Cords" in the Accessory section of
this manual.
f) Grounded tools must be plugged into an outlet properly installed and grounded
in accordance with all codes and ordinances. Never remove the grounding prong or
modify the plug in any way. Do not use any adapter plugs. Check with a qualified electri-
cian if you are in doubt as to whether the outlet is properly grounded. If the tool should
electrically malfunction or break down, grounding provides a low resistance path to carry
electricity away from the user.
3. PERSONAL SAFETY
a) Stay alert, watch what you are doing and use common sense when operating a
power tool. Do not use tool while tired or under the influence of drugs, alcohol,
or medication. A moment of inattention while operating power tools may result in seri-
ous personal injury.
Hammer Drill
NA-WT300K C19-M-050727.indd 2
All manuals and user guides at all-guides.com
WT300K
2005-7-27 17:57:16