Philips 15L5082Q Mode D'emploi page 3

APPLICATION
keyboard
mouse
4
All manuals and user guides at all-guides.com
USB HUB
phone / PBX
printer
scanner
joystick
System requirements
Hardware: a PC which supports the USB function and has a USB
Software: Windows system which supports USB
Installation of USB module
1. Turn off the monitor and unplug the power card
2. Remove the cover of "USBAY" at the back of the
monitor.
3. Insert USB module into the slot
4. Fix the USB module to the monitor by screwing
5. Do not tighten the fixing nut excessively (use fingers
to tighten screws) If screwed too right, the unit may
not connect properly!
1 1 2 2 3 3
= = 4 4 5 5 6 6
7 7 8 8 9 9
R R SEKR SEKR SEKR
* * 0 0 # #
6. Plug-in the power cord and turn on the monitor.
To establish the USB connection
7. Insert disk.
8. The two ends of USB cable attached are different.
Plug-in the flat end into the "upstream" outlet of the
USB module.
9. Plug-in the other end into the USB outlet of the PC.
10. Windows recognises two new pieces of hardware
-philips USB hub
-USB Human Interface Device
This last item is presented through a wizard.
Follow the "next" steps on screen (choose the
"recommended" options) until installation has been
finished.
INSTALLATION
outlet
(OSR2.1 or higher).