Aleratec 350115 Guide De Démarrage Rapide page 5

All manuals and user guides at all-guides.com
Using the HDD Copy Cruiser Mini
Duplicating Hard Drives
1. Use the included power adapter and cord to plug the HDD Copy Cruiser Mini into
a power outlet.
2. Insert the SATA Hard Drive you want to copy into the slot marked "SOURCE".
When inserting, align the SATA port on the Hard Drive with the SATA connector in
the drive bay slot.
3. Insert the destination SATA Hard Drive into the slot marked "TARGET". When
inserting, align the SATA port on the Hard Drive with the SATA connector in the
drive bay slot.
Note: Make sure the target Hard Drive has the same or higher capacity than your
source Hard Drive. The duplication process will not start if the target drive has
a lower capacity. Also make sure the unit is not connected to a PC through the
USB port.
4. Power on the HDD Copy Cruiser Mini.
5. Press and hold the Copy button for 5 seconds and release. The Source indicator
light will turn on and the Target indicator light will flash. Push the Copy button
again to begin the duplication process. The first status bar indicator light will begin
flashing when the clone process starts.
Note: Pressing the Start button will also erase all data on the target drive.
6. The duplication process is complete when the status bar reaches 100% and stops
blinking.
7. Power off the HDD Copy Cruiser Mini to remove the hard drives.
www.aleratec.com 3