Global FE-105D5fOL Guide De L'utilisateur

OWNER'S MANUAL
BELT DRIVE DRUM FAN
All manuals and user guides at all-guides.com
READ AND SAVE THESE INSTRUCTIONS
CAUTION
: Read and follow all instructions before operating fan.
Do not use fan if any part is damaged or missing.
WARNING
:
• To reduce the risk of fire or electrical shock, do not expose to water or rain.
• To reduce the risk of fire or electrical shock, do not use this fan with any solid
state speed control device.
• Automatically operated device - To reduce the risk of injury, disconnect from
power supply before servicing.
• If the power supply cord is damaged, contact your local service centre or a
qualified electrician to install an appropriate replacement cord to prevent any
injury or damage.
• The appliance does not apply to be used in locations where special conditions
prevail, such as the presence of a corrosive or explosive atmosphere ( dust,
vapour or gas ).
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
RULES FOR SAFE OPERATION
:
1. Never insert fingers or any other objects through the grill guard when fan is in
operation.
2. Disconnect the fan from its power source when moving from one location to
another.
3. Disconnect the fan from its power source when removing guards for cleaning.
4. Be sure fan is on a stable, flat surface when in operation.
5. Do not use fan in windows. Rain and moisture may create electrical hazard.
6. Close supervision is necessary when this fan is used near children, the elderly
and pets.
7. Do not place the fan near an open flame, cooking or heating appliance, or hot
surface.
8. This fan should not be operated outside.
CAUTION
: Do not alter the fan's assembly.
WARNING
: Be sure that both front and rear guard screws are completely
tightened in locking position before operation.
WHEEL ASSEMBLY INSTRUCTIONS
1 2
Axle shaft
Wheel hex bolts & washers
Frame
1. Insert axle shaft through hole in frame. Align holes in axle and frame and
secure screws and washers as shown.
2. Slide in each wheel over end of each axle shaft and secure with hex bolts and
washers.
3. Tighten fasteners securely.
OPERATING INSTRUCTIONS
SPEED CONTROL
:
Select air speed by setting switch to either HIGH(2) - LOW(1) - OFF(0).
It is normal for the motor to feel warm to touch after continuous operation.
This fan features a thermostat that will automatically shut off should it overheat
for any reason. If this happens, immediately unplug the fan from the outlet.
CLEANING
WARNING
: Unplug from electrical supply source before cleaning.
1. Use soft damp cloth to clean, then wipe with dry cloth.
2. Do not use a cleaning solution that is harmful to paints or plastics.
3. Do not bend the blades.
RATING
# 600554
FE-105D5fOL(H) 120V~ 60Hz 735W 6.5A
# 600555
FE-120D5fOL(H) 120V~ 60Hz 1120W 9.0A
3