Remington R300 Mode D'emploi page 19

All manuals and user guides at all-guides.com
troubleshooting Guide
pOSSIBLE
prOBLEm CaUSE
Piston hangs Tool overdriven.
out of muzzle.
Piston not properly
assembled in rela-
tion to barrel screw.
Broken piston.
Overdriven fas- Excessive power.
tener.
Piston jammed. Overdriving of fas-
tener (see above).
Dirty or damaged
Expended load
will not extract. chamber.
Broken ejector.
Reduction or Piston not returning
to full rear position.
loss of power
Worn piston ring or
broken piston.
Tool does not Misassembled or
completely de- damaged breech
press. and firing pin parts.
119586
rEmEDY
Tap piston on a hard
surface until piston is
pushed back into the
muzzle (see Overdriven
Fastener, below).
Remove barrel assem-
bly. Follow instructions
for barrel replacement
(see page 18). Replace
all damaged or missing
parts.
Replace barrel assem-
bly or take tool to your
distributor.
Change either to next
lower powder load or next
longer length fastener.
Remove barrel assem-
bly. Follow instructions
for barrel replacement
(see page 18). Replace
other parts if damaged.
Clean chamber. If loads
will not chamber with
slip-fit or extraction dif-
ficulties continue, take
tool to your distributor.
Replace barrel assem-
bly or take tool to your
distributor.
Barrel must be snapped
to the full extended posi-
tion to properly position
piston against breech.
Replace barrel assem-
bly or take tool to your
distributor.
Remove breech and
check all parts for correct
fit assembly.
19