Publicité
Les langues disponibles
Les langues disponibles
Amplifier Owner's Manual
INPUT
Connect preamp signal cables from headunit to these input.
CROSSOVER FREQUENCY
Controls the crossover point for the speaker outputs.
OUTPUT
Provides a full range signal for an additional amplifier. There is no signal
loss if using this output.
+12V
This must be connected to the fused positive terminal (+12V) of the car's
battery. The fuse must be located within 18 inches of the battery.
REMOTE
This must be connected to switched +12V, usually a trigger wire coming
from the head unit or ignition.
GROUND
This must be connected to the negative terminal of the car's battery or
bolted to a clean, unpainted part of the chassis of the vehicle.
NOTE: Visible through the plexiglass cover, a single blue power LED is located in the lower corner of all Z amplifiers.
All manuals and user guides at all-guides.com
2 Channel Power Amplifier
Z250.2
Z250.2
BASS BOOST
Variable bass boost from 0 to +18dB @ 45Hz.
SENS
Used to reach maximum amplifier power with a wide variety of headunits.
CONFIG
FLAT: Crossovers are turned off
HPF: High pass crossover is on
LPF: Low pass crossover is on
L
L
R
R
REMOTE MONITORING DISPLAY (RMD)
Connect optional RMD Voltage Diplay to this port.
SPEAKER OUTPUTS
Used to connect the amplifier to speakers. Z250.2 minimum impedance
is 4 ohms bridged or 2 ohms stereo. Use Right + and Left - to bridge the
channels.
Z250.2
© 2012 Phoenix Gold • www.phoenixgold.com
Publicité
