Zibro R 420 E Manuel D'utilisation page 54

GENERAL DIRECTIONS FOR USE
Below you will find the main steps to be taken for
using your heater. For more details, please refer to
the MANUAL (pages 53 ff.).
1
Remove all packaging materials (refer to Section A, Fig. A).
2
Fill the removable tank ¾ and wait 30 minutes before you
ignite the heater (refer to Section B, Fig. H).
3
Insert the batteries into the battery holder ¹
(refer to Section A, Fig. F).
4
Check whether the combustion chamber ¿ is fully upright
(refer to Section A, Fig. E).
5
Ignite the heater by slowly pushing down the flame regulator
· and the ignition button » simultaneously (refer to Section
C, Fig. J and K).
6
After igniting the heater it will take 10 to 15 minutes before
you can check if the heater burns well (refer to Section D).
7
Switch off the heater (refer to Section E).
•
The first time you ignite your heater it will smell
like 'new' for a short time.
•
Store your fuel in a cool and dark place.
•
Fuel has a limited shelf life. Start every heating
season with new fuel.
•
The right quality of fuel will be assured, when you
use Zibro Extra or Zibro Kristal for your heater.
•
If you change to another brand and/or type of
paraffin oil, you must first finish up all the
remaining fuel in the heater.
MAIN COMPONENTS
³ OFF - button (for
emergency stop)
·
Knurled wick
adjustment knob
»
Ignition button
Combustion chamber
´
Combustion chamber
handle
² Fuel indicator
¶ Grill
º
Lid for removable
tank
¾
Removable tank
µ
Fuel gauge
removable tank
¸
Ignition coil
¹ Battery holder
Air quality control
system
Information display
(E-Guard)
Wick height lock
4
51