Chauvet DJ Data Stream 5 Manuel De Référence page 4

Data Stream™ 4 QRG
AC Power
Fuse Replacement
DMX Linking
Mounting
Overhead Mounting
Diagram
All manuals and user guides at all-guides.com
Data Stream™ 4 has an auto-ranging power supply that works with a voltage
range of 100–240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the fuse holder from its housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
Disconnect the product from power before replacing the fuse.
The Data Stream™ 4 works with DMX controllers. For information
about configuring Data Stream™ 4
download the User
http://www.chauvetlighting.com/product-manuals-literature/. For information about
DMX download the Chauvet DMX Primer, from the Chauvet website:
http://www.chauvetlighting.com/downloads/DMX_Primer_rev05_WO.pdf.
Before mounting the Data Stream™ 4, read the
Data Stream™ 4 conveniently mounts in a single rack space (1U). If mounting
overhead, make sure the mounting clamps (such as CLP-15 clamps from
Chauvet) are capable of supporting the weight of the product. Always use a
mounting point and at least one safety cable per product. For the Chauvet line of
mounting clamps, go to www.chauvetlighting.com/cables-clamps-main.html.
Mounting Clamp
(such as CLP-15 from Chauvet)
for additional DMX operation,
Manual from
Safety Notes
Rear View
(such as CH-05 from Chauvet)
Bottom View
4
EN
the Chauvet website:
in this QRG. The
Safety Cable