Publicité
Les langues disponibles
Les langues disponibles
1. To switch the laser distance measurer on, press the
"ON/OFF" key (15) until the display (1) shows
information;
2. To turn the measurer off, press the "ON/OFF" key until the
displayed information disappears;
3. If the measurer is on and no key is pressed during:
- 30s - The laser turns off.
- 180s – The measurer turns off.
Never leave the laser distance measurer unattended
when it is switched on. Always turn the measurer off
after each use.
To change the unit of measurement, press the measuring
unit key (18) and select between: m, ft, in and ft + in.
When measuring you can consider two reference points,
the rear and the front of the instrument.
To change the measurement reference point, press the
Measurement Reference Point key (14). There is an acoustic
signal when the reference point is changed. The selected
reference point is shown in the field for the reference point
in the display (20 and 21).
Whenever you switch the measurer on, the set reference
point is the rear of the meter.
Press the "CLEAR" (16) key to delete the last action or clear
the measured value.
1. Press the measurement key (9) to switch the laser;
2. Press the measurement key again to start. The measured
value is shown immediately.
1. Press the continuous measurement key (11) to activate
continuous measurement. The maximum and minimum
measured distances are shown on the display;
2. Press the measurement key (9) or the "CLEAR" key (16)
to deactivate continuous measurement.
The last measured value is displayed in the summary line.
1. Press the function key (10) once and the symbol "
appears in the display field for the measuring mode (24);
2. Press the measurement key (9) to take the first
measurement;
3. Press the measurement key again to take the second
measurement.
The values for length (L), width (W), perimeter (P) and area
(A) are shown on the display.
1. Press the function key (10) twice and the symbol "
" é appears in the display field for the measuring mode
(24);
2. Press the measurement key (9) to take the first
measurement;
3. Press the measurement key again to take the second
measurement;
4. Press the measurement key over again to take the third
measurement.
The values for length (L), width (W), height (H) and volume
(V) are shown on the display.
1. Press the function key (10) three times and the symbols
"
" is displayed in the function field of the display;
2. Measure the two distances, as shown in the picture, in
numerical sequence. The height will be calculated
automatically and shown on the display.
1. Press the function key (10) 4 times to activate the
function, the symbol, the symbol "
function field on the display;
2. Measure the 3 distances, as depicted in the figure, in
numerical sequence. The height will be calculated
automatically and shown on the display.
"
" appears in the
Publicité
