Winplus TypeS BT56883 Mode D'emploi page 10

C) LICENSE PLATE MOUNT OPTION
This installation is based on powering the Camera over the reverse tail lights. When installed as directed,
the camera image will only appear when the vehicle is in reverse.
Caution: This unit is designed to operate on a 12V/24V DC NEGATIVE GROUND electrical system.
Connecting to other types of electrical systems will cause damage to your vehicle. Please contact the
manufacturer if you are unaware of the system type in your vehicle.
1. Remove your license plate.
2. Determine the best route for the License Plate Mount Adapter from the top of your license plate to the
inside of the vehicle. You may need to drill a small hole in the panel behind where the license plate is
situated.
3. Take the adapter and run the cable through the Rubber Ring Grommet, then from the outside of your
car to the inside. Pull the cable through so that there is a small amount of slack and you can still move
the Camera around the license plate.
6
All manuals and user guides at all-guides.com
Reverse Light Power Wires
Camera Cable