Publicité
Les langues disponibles
Les langues disponibles
ENERGY-SAVING TIPS
Install the fridge or freezer in a cool place out of direct sunlight
and away from cookers, heaters, dishwashers or any hot air
emitting items.
Do not set the fridge and freezer temperatures lower than
necessary. Set the internal temperature within the correct range
e.g. adjust the thermostat at middle position for 4°C in the fridge
compartment and -18°C in the freezer respectively.
Let pre-cooked foods cool down before placing them in the fridge
GB
or freezer. This will prevent the internal temperature of the fridge
from rising.
Keep your fridge full, but not over crowded, this helps reduce
"cold" air loss. Meanwhile, avoid overloading the fridge or
freezer. Try to leave about 20% free space for air circulation.
To prevent cold air escaping, limit the frequency of opening door.
When retuning from shopping, sort foods to be kept in your
fridge before opening the door. Only open the door to put food in
or take it out.
Make sure the door seal is clean and in good condition. It should
hold a piece of paper tightly in place when shut.
Defrost regularly or when ice is more than 5mm thick. Thick ice
covering the inner sides signi cantly increases energy use.
The combination of the drawers, baskets and shelves shown in
the device description is optimal for e cient energy savings.
Changing the combination proposition could alter the e ciency.
42
Reverse door
This refrigerator can be opened either from the left or right side.
The default way of opening the door is from the right side. If
you want to open the door from the left side, please follow the
instructions below.
Tools Required: Phillips style screwdriver / Flat blated
screwdriver / Hexagonal spanner
• If you want to have the door swing reversed, we recommend
that you contact a quali ed technician. You should only try to
reverse the door yourself if you believe that you are quali ed
to do so.
• Ensure the unit is unplugged and empty.
• Adjust the two levelling feet to their highest position.
• To take the door off it is necessary to tilt the unit backwards.
You should rest the unit on something solid so that it will not
slip during the door reversing process.
• All parts removed must be saved to do the reinstallation of the
door.
• The refrigerator inclination angle should be less than 45°.
• Do not lay the unit fat as this may damage the coolant system.
• You should rest the Appliance on something solid e.g. a chair
just below the top panel.
• We recommend that 2 people handle the unit during
assembly.
GB
43
Publicité
