GB AKG 317 Notice D'utilisation page 15

13. Fit the left-side top hinge
Tighten the torsion spring approx.
1/2 turn (anti clockwise on left
side, clockwise on right.)
16. Retighten the top panel
screws using a screwdriver.
18. After reversing the door, it is important to check that the sealing strip provides a tight
seal all the way round. If it does not, carefully heat the strip all the way round using a hair
dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet.
Be careful not to heat the strip so much that it melts!
The must be allowed to stabilise in an upright position for at least an hour before
appliance
being switched on again..
14. Secure the top hinge in
position.
17. Refit the lock housing and
lock pin.
15
15. Raise the appliance into
uppight possion. Click the top
panel into place (it is secured in
three places.)
GB