Télécharger Imprimer la page

NORMARC Rapala CRUZER M1 Manuel D'utilisation page 8

Publicité

Les langues disponibles

Les langues disponibles

WIND BREAK POSITION
This shelter is equipped with a locking system that positions
the shelter to be used as a wind break on colder days. The wind
break lock pivots over onto the J-Pole as shown in FIGURE 11.
SET-UP AND TAKE-DOWN INSTRUCTIONS
SET-UP: From the outside or inside of the shelter depending on
your preference, start with the bottom cross brace pole and
pull out all cross brace poles and snap into place. As you
extend out each cross brace pole and snap into place, flip
all cross braces over to the in use position. Secure all
spreader poles in between front cross brace poles by
snapping C-clips over cross brace poles.
TAKE-DOWN: Close all window covers, vent covers and zip
door shut. Remove all spreader poles and place in bottom
of sled. Starting with the rear cross brace, push snap
buttons in and retract all cross brace poles to their shortest
length. Work from the rear cross brace to the front cross
brace that lies on the ground/ice. Flip all poles back. Use
extreme caution when flipping poles for transport
position and make sure no part of the skin gets pinched,
caught or stuck between any poles or in any pinch points.
Fold excess skin inside sled when complete.
Note: Use extreme caution so you don't rip or tear any
portion of the skin, especially around the hinges or any
pinch point areas.
8
All manuals and user guides at all-guides.com
FIGURE 11
LONG-TERM STORAGE
www.facebook.com/rapalaarmy
Cruzer M1 Flip-Style Sled Shelter
J-pole
wind break lock
Always make sure your ice shelter is completely dry before
storing for long periods of time. Storing your ice shelter
when damp or wet may cause mold and mildew damage.
Remove skin from ice shelter sled and poles.
Clean all salt, moisture and debris from your shelter skin,
sled and poles. Wipe down poles with a wet rag.
Note: Lubricate the slide poles with a silicon spray at
least seasonally. Do not use oil or grease as a lubricant.
Note: Before attaching skin for use, spray silicon spray
inside of poles for ease of sliding.
Store skin, poles an sled in a cool, dry place away from
rodents.
Operator's Manual
hinge assembly
Visit us at: www.rapala.ca

Publicité

loading

Ce manuel est également adapté pour:

Rss-1