EIBENSTOCK MXT 120/2 C Notice Originale page 13

Tool Change
Attention!
Before any work on the tool, disconnect the plug from the mains!
When inserting the tool, you could catch your hands. For this reason,
always wear protective gloves for changing the tool.
The work spindle of the machine has an M 14 - internal thread. Keep
threads and front surface clean.
Please hold up with a jaw wrench 22 to remove the stirring rod.
Switching on and off
Short-Time Operation
Switching-on: press the on/off switch
Switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off: press the on/off switch and let it go off again
Attention!
In case of every stop of the machine or a power cut, the
!
lock-on button has to be released immediately by pressing
the ON/OFF switch. So you can avoid an unintentional
restart of the machine (physical hazard).
The stirrer is equipped with an electronic switch.
With this switch the speed can be regulated according to the pressure on
the button. The use is only recommended for the starting and running out of
the machine to avoid material flying around. A permanent operation with
reduced speed will cause an overload because the motor then gets less
cooling air and therefor the machine will be overheated much faster.
Speed Selection
The MXT 120/2C is equipped with a mechanical two-speed gearbox.
Select the required speed by pressing-in, shifting and engaging again the
gear switch. Slower speed is the position towards to the work spindle. Only
change the speed when the machine is not running. You can possibly
support the speed selection by moving the work spindle slightly.
13