Publicité
Les langues disponibles
Les langues disponibles
NaviTrack™ Line Transmitter
Features
Inductive Mode
1. Be sure that the transmitter is positioned correctly over
the line.
2. To use a frequency in the inductive mode select the
frequency and then push that same frequency a sec-
ond time. The inductive red LED will light up in ad-
dition to the selected frequency to let the user know
that the line transmitter is transmitting inductively on
that frequency.
8
All manuals and user guides at all-guides.com
25' Coil Cords (when extended)
Specially designed, hybrid copper and stainless steel air-
craft grade coiled cables allow the leads to be stretched
out to offer more freedom in choosing grounding points
and connections to the line.
Ridge Tool Company
Lower frequencies couple poorly, therefore the internal
coil has been optimized for higher frequencies. 512Hz
cannot be used inductively. (The transmitter will de-
fault to 33 kHz if an inductive clamp is used.)
To avoid tangled cords, "feed" the cords back into
the pockets, clip going last, when storing.
Like This:
Not like this
Publicité
