ALTAI A175FD Instructions D'installation page 3

All manuals and user guides at all-guides.com
constructed of masonry or timber studding clad in plasterboard.
• Before commencing work, a risk assessment must be carried out,
to confirm that the wall can support 3 times the weight of the
screen and all its accessories.
• Do not use this product for anything other than its intended
purpose
• Electrovision accepts no responsibility for damage to the wall nor
the appliance attached to the bracket, nor any consequential
damage or injury caused by improper installation, improper use,
overloading or unauthorised modification of the product.
1a. If the screen has a flat back, attach the vertical parts of the
1b. If the screen has a curved back, attach the vertical parts of the
bracket to the mounting holes in the screen using the 16 mm
the back of the screen.
INSTALLATION
[D/E]
[L/M/N]
[F/G/H]
[D/E]
[L/M/N]
[ C ]
[I/J/K]
Page 3
bracket to the
holes in the screen using the
16 mm machine screws,
plain washers
shakeproof washers
shown. Check
screws used
correct threads to fit properly
into the female threads on
the screen. Do not drill into
the back of the screen.
machine screws,
washers and
washers, inserting
spacer [C] between
bracket and the back of the
screen. Check
screws used
correct threads to fit properly
into the female threads on
the screen. Do not drill into
mounting
and
as
that the
have the
plain
shakeproof
the
the
that the
have the