Polycom SpectraLink 8002 Mode D'emploi page 4

GETTING STARTED
Your SpectraLink 8002 Wireless Telephone uses radio wave technology to
send and receive voice and data transmissions. It is designed to operate
much like a cell phone. However, the handset uses the private
communication system installed in your facility and will not operate
outside the area covered by this system.
The handset's Battery Pack must be fully charged before
its first use. Place the handset into the Charger for a
minimum of two hours before using it for the first time.
Basic Operation
If you want to Then
Turn the handset on
Turn the handset off
Unlock the keypad
Lock the keypad
Place a call
4
All manuals and user guides at all-guides.com
Press and hold the
sound.
Press and hold the
sound. If you are in a call, hang up first, then
turn off the handset.
Press the
Unlk
While in standby mode press
.
Select
Press the
START
Dial the numbers and listen for the ring to
indicate the alerting of the called party.
Note: Line 1 is the default line
START
key until two chirps
key. One chirp will
END
softkey, then .
#
FCN
key and wait for a dial tone.
, then
English