Publicité
Les langues disponibles
Les langues disponibles
Prepare the Hood
1 ] If present, remove all protective polyfilm from the hood and/or parts .
2 ] Using the finger cup, remove the grease filters from the hood by pushing down
filter out
.
3 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap . Remove both
screws holding damper assembly to hood . Remove parts bag (captured behind the damper
assembly) . Remove damper assembly from inside the hood and keep the screws for further
use .
EZ1
BRACKETS
4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood
and set it aside .
B
HD0918
HD0919
HD0920
C
SCR EWS
DAMPER
ASSEMBLY
and tilting
9
Publicité
