Publicité
Les langues disponibles
Les langues disponibles
PROGRAMMED PLAYBACK
1. Press the PLAY/PAUSE(
) button and after 3 seconds the STOP(
2. Press the PROG. button. The track number and 'PROG' will flash on the display
indicating the first selection.
3. Press BACKWARD (
) or FORW ARD (
be programmed. The track number which wil l be p rogrammed will flash on the
display.
4. Press the PROG. button to enter the track into memory.
5. Repeat the steps 2 and 4 to program up to 24 tracks.
6. Press PLAY/PAUSE (
) button once to start programmed playback.
7. To cancel programmed pl ayback, press the STOP(
PROG. button for 3 seconds to exit the programming.
Note: Programmes can be set in Stop mode only.
During program playback, if you wish to repeat the enti re programmed playback,
press the MODE button repeatedly until the (
display.
SPECIAL FUNCTIONS
Dynamic Bass Boost
Set the BASS BOOST switch to " ON " positi on to enjoy a more powerful Bass sound.
Note: Since Bass Boost performance will change depending on the volume level,
sound may be distorted if the volume is set too
until the sound quality is improved.
Hold switch
You can lock the control s on your CD player to prevent accidental button presses.
Slide HOLD switch to the " ON " positi on, if a button is pressed when the hold
function is active "HOLD" will be shown in the display.
Auto Power Off
When the unit is stopped (standby mode) for approximately 60 seconds, the Auto Power
Off function will activated and turn the unit off automatically.
All manuals and user guides at all-guides.com
) button.
) button to sel ect the desired track to
) button and then press the
) indicator appears on the
high.Lower the volume level
EN - 7
5
6
MAINTENANCE
Cleaning the unit
Wipe the outside surface of the unit with a soft cloth moistened with water and mild soap.
Handling CDs
Your CD pl ayer has been especially designed for the reproduction of compact discs
bearing the CD mark. No other discs should be loaded into the player.
Always place the disc in tray with the label facing up.
Although compact discs are impervious to wear during play, damage to the surface of a
disc through improper handling will result in playback irregularities.
To preserve your compact discs, please handle them with care.
Although minute dust particles and fingerprints should have no effect on playback, you
should keep the surface of the recorded side of your discs clean by wiping the disc with a
clean, dry, lint-free soft cloth with straight movements from the centre outwards.
Never use record cleaners, record sprays, antistatic sprays, liquids or chemical based
liquids to clean the surface of a disc. They may in fact irreparably damage the disc's
plastic surface.
Always return the disc to its protective plastic case when not using it. Avoid exposing discs
to direct sunlight, excessive temperatures or high humidity for extended periods of time.
Do not write on the label side of the disc with a ball/point pen as this may scratch the disc.
SPECIFICATIONS
Audio
D/A conversion
Frequency response
Wow and flutter
No. of channels
Output level
Bass Boost effect (100Hz)
General
Power r equiremen ts
Power consumption
Note: Specifications and the design are subject to possible modifications without notice
due to improvement.
1-bit DAC 8 times oversampling
20-20,000Hz
Below measur able limits
2 channels (stereo)
Li ne output: 0.6V rms (47KW )
Phone: 15mW (32W)
+ 6 dB
-2 x LR6 / UM-3 / "AA" alkaline battery
- DC in 4.5V jack accepts AC power adaptor
(centre positive)
0.8W (DC 3V)
EN - 8
Publicité
